Electronic Super Knips VDE precision side cutter insulated, edges approx. 54 HRC, 125 mm - Knipex 78 06 125

In electronics the cut at the board decides the result, and for live working the tool has to be insulated as well. The Electronic Super Knips VDE cuts soft wire from 0.2 mm dia. cleanly and is tested to DIN EN 60900 and IEC 60900.

Benefits

• Ground, very sharp cutting edges without bevel, shear cut with a controlled micro cutting edge offset for a long service life.
• Precisely shaped tips cut wires close to a surface from 0.2 mm dia.
• Cutting edge hardness approx. 54 HRC, soft wire up to 1.6 mm dia. and medium hard wire up to 1.0 mm dia.
• Extremely smooth movement with opening spring and opening limiter for low fatigue over many cuts in sequence.
• Joint with stainless steel rivet, slim head of 13.5 mm width with 9 mm jaw length.
• Insulated multi-component sleeves, VDE tested, so the tool completes an existing set of VDE tools.

Areas of use

Electronics manufacturing and repair, precision mechanics, control cabinet and test bay work. Wherever thin wires are cut flush without damaging the assembly and work on live parts requires an insulated tool.

Standards and conformity

The pliers comply with DIN ISO 9654 for electronics diagonal cutters and with DIN EN 60900 and IEC 60900 for insulated hand tools used for live working. According to the manufacturer they contain no substances of very high concern under REACH. The RoHS directive does not apply.