Electronic Super Knips burnished, precision cutter with lead catcher, 125 mm - Knipex 78 91 125

On a populated board, component leads have to be trimmed flush without the offcut flying off. The 78 91 125 Electronic Super Knips uses a shear cut with a controlled micro cutting edge offset to cut wires from 0.2 mm dia. upwards, and the lead catcher holds the offcut in place.

Benefits

• Ground, very sharp cutting edges without bevel for an ultra precise cut even on the thinnest wires.
• Precisely shaped tips cut wires lying close to a surface from 0.2 mm dia., so right at the board.
• Shear cut with controlled micro cutting edge offset gives the edges a long service life.
• Lead catcher prevents uncontrolled loss of the cut wire ends.
• Additional precision ground edges with a very small bevel handle hard wire up to 0.6 mm dia.
• Extremely smooth movement with opening spring and opening limiter, the joint runs on a stainless steel rivet.
• Special tool steel, burnished, cutting edges additionally induction hardened to approx. 62 HRC.

Areas of use

Electronics manufacturing and repair, board assembly and rework, precision engineering, model making and laboratory work.

Standards and conformity

The pliers comply with DIN ISO 9654. According to the manufacturer they contain no substances of very high concern under REACH, and the RoHS directive does not apply to this product.