Crimping die for insulated and non-insulated cable connectors 0.1 - 0.5 mm² - Knipex 97 49 21

At cross-sections from 0.1 to 0.5 mm² the shape of the nest decides whether the crimp holds or the fine conductor tears off. Crimping die 97 49 21 covers exactly this lower range and works with insulated as well as non-insulated cable connectors, fitted into a Knipex crimp system plier of the 97 43 xx series.

Benefits

• Application for insulated and non-insulated cable connectors, one die for both types of connector.
• Capacity from 0.1 to 0.5 mm², covering the fine cross-section range for which standard dies are too coarse.
• Interchangeable die for the manual and electromechanical Knipex crimp system pliers of the 97 43 xx series, one plier body carries many contact systems.
• Compact component of 32 x 10 mm and 42 g, changing the die is quicker than reaching for a second plier.

Areas of use

Electronics and control system building, measuring technology, test equipment construction and service on devices with fine-stranded wiring. Wherever cores below 0.5 mm² are terminated on cable connectors, the die replaces a dedicated fine crimping plier.

Standards and conformity

The manufacturer does not state a tool standard for this crimping die. According to the manufacturer the die contains no substances of very high concern under REACH. The RoHS directive is stated as not applicable.