ESD plastic tweezers, straight with blunt tips, carbon fibre reinforced, dissipative, 115 mm - Knipex 92 09 05 ESD

Handling SMD components, glass or ceramic parts calls for a tool that neither scratches the surface nor exposes it to static charge. The 92 09 05 ESD plastic tweezers are made of 30% carbon fibre reinforced plastic and keep the surface resistance between 10^2 and 10^4 ohms, so differences in potential between operator and component are equalised in a controlled way.

Benefits

• 30% carbon fibre reinforced plastic, a very good electrical and thermal conductor, highly resistant to abrasion and scratching.
• Surface resistance of 10^2 to 10^4 ohms for controlled compensation of potential differences between operator and electronic component.
• Temperature-stable up to 130 degrees Celsius, short-term use up to 190 degrees Celsius is possible.
• Fully elastic, fatigue-resistant, vibration-damping and water-repellent, with good chemical resistance to most oils, greases, fuels and non-polar solvents.
• Straight blunt tips with a tip width (A) of 0.12 mm for maximum surface protection.
• Not magnetisable and matt finished, 115 mm long at a weight of only 4 g.

Areas of use

Electronics manufacturing and repair, work on micro-mechanical assemblies and on glass and ceramic components. Useful wherever the surface of the part must stay unmarked and electrostatic discharge has to be ruled out. The tweezers are also available in the 92 00 05 ESD set.

Standards and conformity

The manufacturer states DIN EN 61340-5-1 for use in EPA areas, the tweezers are ESD tested. According to the manufacturer they contain no substances of very high concern under REACH. The RoHS directive does not apply.