Electronics diagonal cutter ESD with box joint, round head without bevel, 130 mm - Knipex 77 82 130 ESD

When populating and reworking assemblies, a clean cut close to the component is what counts. The 77 82 130 ESD electronics diagonal cutter is 130 mm long, weighs 81 g and cuts soft wire up to 1.6 mm dia. The box joint absorbs the cutting forces without any play, and the round head without bevel reaches into densely populated areas with a head width of only 13 mm.

Benefits

• Durable, load-optimised design with a backlash-free box joint, which gives a direct feel when working.
• Slim sleeves drawn up towards the head for fine and comfortable gripping between thumb and index finger.
• Less physical effort thanks to the high transmission ratio, plus a low-friction double spring for smooth and even opening.
• Cutting edges additionally laser hardened to approximately 62 HRC, so the edge stays sharp for a long time.
• Mirror polished head with a fine oil film for good rust protection, with no circuit faults caused by flaking chrome.
• ESD version to DIN EN 61 340-5 for use at electrostatically protected workstations.

Areas of use

Assembly, rework and repair of printed circuit boards in the EPA, semiconductor production, precision mechanics, laboratory and prototype construction. Wherever electrostatically sensitive components are handled and a clean fine cut is still required.

Standards and conformity

The pliers comply with DIN ISO 9654 and DIN EN 61 340-5. According to the manufacturer they contain no substances of very high concern in the sense of REACH. The RoHS directive is not applicable to this product.