SCS dual conductor coil cord 1.5 m, right angle 3.4 mm plug, 1 megohm per conductor, gray - Desco 2360R

At a continuously monitored workstation, the link between wrist strap and monitor has to hold even if one conductor is damaged. The SCS 2360R coil cord carries two separate conductors, each with its own 1 megohm current limiting resistor. The plug is angled at 90 degrees, so the cord leaves the jack sideways instead of sticking straight out.

Key benefits

• Redundant grounding: two conductors, the operator stays grounded through one if the other is damaged
• Right angle 3.4 mm mono plug: the cord runs off to the side, useful where space in front of the monitor jack is tight
• Operator safety: a 1 megohm resistor in each conductor limits current on accidental contact with equipment line voltage
• Long service life: resistor connection strain relief tested to over 200,000 cycles in the ANSI/ESD S1.1 bending life test, against a requirement of 16,000
• Wider plug grip for easy insertion and removal

Applications

Connecting dual-wire wrist straps to SCS dual-wire continuous monitors at soldering, assembly and test stations, particularly where the monitor sits under the bench edge or on a wall.

Standards

The resistors meet the resistance requirements of ANSI/ESD S20.20 and EIA 625, bending life is tested to ANSI/ESD S1.1. The cord forms part of a personnel grounding system to IEC 61340-5-1.