Phillips bit PH2 in the long version, 64 mm overall length, 4 mm blade - Delvo DLB2131

Some screws sit so deep in the housing that a 44 mm bit no longer reaches the head and the operator picks up an extension. The 64 mm version of the Phillips No. 2 bit saves exactly that step, because it bridges the extra 20 mm in one piece.

Benefits

• Overall length of 64 mm instead of 44 mm, which opens up heads inside through holes, behind stiffening ribs and under wiring harnesses.
• One piece instead of bit plus extension, so only one fit in the drive train and no extra angular play.
• Blade diameter of 4 mm, the size the manufacturer assigns to Phillips No. 2, with an 11 mm blade length for recessed heads.
• Hardness grade H, the hardest grade of the NK4D range, from a special alloy with controlled heat treatment and close hardness testing.
• Half-round 4 mm shank, seated directly in the H4 holder of the Delvo screwdrivers, no adapter needed.

Applications

Deep seated joints in equipment and housing construction, control cabinets with fittings in front of the screw position, repair work on populated assemblies. In those places the long version replaces the pairing of a short bit and an extension.

Matching accessories

• Delvo electric screwdrivers with a 4 mm half-round holder, among them DLV-7410-BME6, DLV-7420A BME6 and DLV-7331-BME6
• Adapter ADA-HR4-D63 where the screwdriver has a 1/4 inch holder
• Ring magnets MAG-RING-4,7 and MAG-RING-6,0 so the screw does not drop off on the long way to the joint
• Short version of the same recess: DLB 2130 with 44 mm, and DLB 2126 for Phillips No. 1