ESD electric screwdriver lever start with vacuum pick-up 0.05 - 0.49 Nm, 700 - 1000 rpm - Delvo DLV-7325-BKE6

Placing small screws deep inside a housing costs time and often goes wrong. This electric screwdriver holds the screw on the bit with its vacuum pick-up and tightens it to a torque set anywhere between 0.05 and 0.49 Nm, reliably limited by the shut-off clutch.

Benefits

• Vacuum pick-up keeps the screw on the bit, including overhead and in poorly accessible spots.
• Torque infinitely adjustable from 0.05 to 0.49 Nm, matched to small screws in electronic assemblies.
• Shut-off clutch releases the drive at the set value and keeps the thread from being stripped.
• Lever start, tightening begins only when the operator triggers it.
• Speed of 700 to 1000 rpm at a tool weight of 350 g.
• ESD design for workplaces handling electrostatic sensitive devices.

Applications

Assembly of electronic modules and precision devices, work deep inside housings, overhead, or wherever the second hand cannot guide the screw.

Matching accessories

Suitable control units are the DLC-1213A-GGB and DLC-1213A-GG with soft start and adjustable speed. Bits with a 4 mm shank can be used through the ADA-HR4-D63 adapter, the BAL-0515 and BAL-1020 tool balancers carry the weight of the tool, and the SGR-14 and SGR-23 screw grids present the screws at the bench.

ESD design

Housing and grip area are dissipative, so no charge collects on the tool that could flash over to the assembly on contact. The screwdriver is therefore intended for use inside an EPA according to IEC 61340-5-1.