Cutting and bending machine Superform/V vertical mounting lead 0.5-0.8 mm pitch 2.54 mm - Iteco 7915101B

Setting axial components upright on the board calls for a pitch that matches the hole pattern. The Superform/V in version 7915.101B works with a fixed pitch of 2.54 mm, the 0.1 inch grid, and cuts and bends taped axial components with lead diameters from 0.5 to 0.8 mm. The Iteco catalogue lists this very version as the standard model of the series.

Operating features

• Tightest pitch of the series - 2.54 mm matches the 0.1 inch grid of common boards.
• Lead diameter 0.5-0.8 mm - the cutting and forming wheels are dimensioned for exactly this range.
• Loop height A 2-6 mm - the returned lead passes over the component body at this height.
• Body diameter up to 3 mm - thicker parts call for a version with a wider pitch.
• Up to 40,000 pieces per hour - the tape runs through the machine without repositioning.
• Body length adjustable from 3 to 15 mm - the machine adapts to the package while the pitch stays fixed.

Applications

Assemblies with a dense 0.1 inch hole pattern: small film resistors, glass bodied small signal diodes and comparable parts whose body diameter stays within 3 mm. The version pays off where the board is densely populated and every part has to save space by standing upright.

Compatibility and scope of supply

The machine is driven by its hand crank. For the Superform/A-AP-S-V-R-RCP range Iteco offers the motor unit 7915.030 in 230 V and 7915.031 in 115 V, both with speed control. According to the catalogue the motor unit is supplied only with the machine assembled and is switched by the foot pedal 600.023. The BR6 tape reel holder (7915.185) is fitted to the side and eases unwinding of the reel. The TNS waste tape expeller 7915.080A is intended for the Superform/A-AP-V-S-R range. Supplied as one machine with the pitch set fixed. Made in Italy.