Supercut/TOCF automatic cutting and forming machine for tubed transistors 220 V - Iteco 7915177

The Supercut/TOCF is the automatic machine for power transistors delivered in tube magazines. It trims the leads and forms them in a single pass: place the tube in the upper guide, the pneumatic clamping, the wire holder and the sliding die do the rest. This version is built for the European 220 V mains and is therefore the common variant in continental Europe.

Operating features

• 220 V version - connects directly to the European mains, no voltage converter needed.
• Two forming steps per cycle - cutting and forming happen in the same setup, the device is gripped only once.
• Up to 3000 parts per hour - the throughput suits series production, not only samples.
• TO220, TO218 and TO126 - three package families on one machine, the fitted die defines the shape.
• Open range of tooling - Iteco lists dies for straight cut, 90 degree bending, stand-off, surface mounting and center lead offset.
• Hood over the working area - the forming zone stays covered during the cycle and is reached through the hand wheel side.

Applications

European electronics manufacturing that processes TO220, TO218 or TO126 from tubes: power supply production, power electronics, lighting equipment and repair shops with recurring batches. Also a replacement for a manual bending fixture when uneven leads start to drive up the reject rate.

Compatibility and scope of supply

The machine is supplied without forming dies. Every lead shape needs its own die from the Iteco range, for example straight cut 131000, 90 degree bending 131300, surface mounting 131400 or stand-off 132400. According to dealer information one clamping piece and one tube holder are included, further packages require the matching parts. Made in Italy.