Component holder kit single piece left or right for Supercut/TS1 - Iteco 180200

When preforming loose radial components, the grip on the part decides how accurate the result is. If the component slips at the moment of the cut, neither the wire length nor the bead height is right. This component holder kit for the Supercut/TS1 clamps the part during the pedal stroke and is supplied as a single piece for either the left or the right side of the machine.

Operating benefits

• Holds the component at the moment of cutting and forming, so wire length and form height stay identical across the whole batch
• Supplied as a single piece, so only the left or only the right side can be equipped or replaced
• Can be retrofitted to existing Supercut/TS1 machines that run without a holder
• Relieves the operator, because the component no longer has to be held against the tool pressure
• Works together with all dies of the TS1 range, because it grips independently of the lead form

Typical applications

• Series production with tight tolerances for wire length and bead height
• Large or heavy components up to 140 mm length that move in the tool
• Workplaces with frequent staff changes and different hand pressure
• Retrofitting older Supercut/TS1 machines without a component holder

Compatibility and scope of delivery

The component holder belongs to the accessories of the pneumatic cutting and forming machine Supercut/TS1 (Iteco 7915.171) and is used together with one of the preforming dies of the 18xxxx number range. The Iteco catalogue 2026 lists the holder principle for the Supercut range as a system available on request. Scope of delivery according to the 2026 price list: one single piece, for either the left or the right side. Please state the required side when ordering. Made in Italy.