Bending die for 90 degree lead bending of radial components Supercut/TS1 - Iteco 181300

Tall electrolytic capacitors and chokes often do not fit upright into a flat housing. This Supercut/TS1 die bends the lead at a right angle so the component is mounted lying on the board. The bending radius is fixed in the tool and comes out identical on every part, unlike hand bending.

Operating benefits

• The right angle bend allows tall components to be mounted lying down and lowers the height of the assembly
• The bending radius is fixed in the tool, so it is reproducible on every part and the wire is not overstretched
• Components mounted lying down have a lower centre of gravity and withstand vibration better
• Cutting and bending run in the same pedal stroke, a second work step is not needed
• The strongest forming operation of the TS1 range, designed for the reinforced cylinders of the machine

Technical data

Typical applications

• Tall electrolytic capacitors in flat device housings
• Chokes and inductors that are mounted lying down
• Assemblies with limited mounting height, for example plug-in cards and power supplies
• Applications with vibration load in which upright components would break off

Compatibility and scope of delivery

This die assembly is intended exclusively for the pneumatic cutting and forming machine Supercut/TS1 (Iteco 7915.171). The machine is supplied without a die, so the die has to be ordered separately. Changing to a different lead form takes only a few movements, which lets one machine cover several component shapes. The same form is available as number 161300 for the smaller Supercut/RS4 (Iteco 7915.166) - the two number ranges are not interchangeable. Scope of delivery: one complete die assembly. Made in Italy.