Preforming die stand-off with lock-in for radial components Supercut/TS1 - Iteco 180600

Anyone placing loose radial components by hand needs leads that hold the body at a defined distance and still keep the part seated in the hole. This die for the Supercut/TS1 produces both in a single pedal stroke: a stand-off bead above the board as a defined spacer and a clinch below the board that holds the component until soldering.

Operating benefits

• The stand-off bead above the board keeps the component body at a constant distance, which allows cleaning and heat dissipation underneath the part
• The lock-in clinch below the board holds the component in position before the solder bath, even when the assembly is turned over
• Cutting and forming happen in the same stroke, so a second work step is not needed
• Designed for the reinforced cylinders of the Supercut/TS1 and therefore for components up to 140 mm length and 45 mm pitch
• The machine output of 2000 pieces per hour is retained with this die

Typical applications

• Electrolytic capacitors that have to stand with an air gap above the board
• Resistors and inductors that dissipate heat
• Assemblies that are turned over or transported before soldering
• Small batch and repair production with changing component types

Compatibility and scope of delivery

This die assembly is intended exclusively for the pneumatic cutting and forming machine Supercut/TS1 (Iteco 7915.171). The machine is supplied without a die, so the die has to be ordered separately. Changing to a different lead form takes only a few movements, which lets one machine cover several component shapes. The same form is available as number 160600 for the smaller Supercut/RS4 (Iteco 7915.166) - the two number ranges are not interchangeable. Scope of delivery: one complete die assembly. Made in Italy.