Cutting die for straight cut without forming Supercut/TS1 - Iteco 181000

Many components already come at the correct pitch but need leads of equal length for clean placement. This Supercut/TS1 die does exactly that: a straight cut to a defined wire length, without a bead and without a clinch. Because no forming takes place, the mechanical load on tool and component is the lowest of the range.

Operating benefits

• Straight cut to a constant wire length without deforming the leads
• Component geometry stays unchanged, which suits pre-formed or sensitive parts
• Without forming work the mechanical load on tool and component is the lowest, so wear is reduced
• A clean cut edge without burr reduces rework before soldering
• Full Supercut/TS1 output of 2000 pieces per hour

Typical applications

• Components that are already supplied at the correct pitch
• Trimming leads before manual placement
• Sensitive components where forming of the wire has to be avoided
• Preparing samples and small batches without a forming requirement

Compatibility and scope of delivery

This die assembly is intended exclusively for the pneumatic cutting and forming machine Supercut/TS1 (Iteco 7915.171). The machine is supplied without a die, so the die has to be ordered separately. Changing to a different lead form takes only a few movements, which lets one machine cover several component shapes. The same form is available as number 161000 for the smaller Supercut/RS4 (Iteco 7915.166) - the two number ranges are not interchangeable. Scope of delivery: one complete die assembly. Made in Italy.