Stationary cutting plate 3.2 mm with standard hole pattern for Supercut/LN5L - Iteco 340211

The long Supercut/LN5L cuts over an area of 53 x 93 mm and therefore needs its own longer cutting plate. This version carries the standard hole pattern of the LN5L range and is 3.2 mm thick, which fixes the lead length after the cut. The plate of the short LN5 does not fit here.

Features

• Format for the long machine - covers the 53 x 93 mm cutting area of the LN5L, more than twice the short plate.
• Plate thickness 3.2 mm - defines the lead length that remains above the plate after the cut.
• Standard LN5L hole pattern - corresponds to the layout drawing that Iteco shows for the long machine in the catalogue.
• Cobalt steel - cutting edge for the burr free guillotine cut against the hardened upper plate.
• Usable as a spare part - a worn plate is exchanged and the machine stays in service.

Applications

Replacement plate for an LN5L in continuous use, a second plate for changing between component families, and conversion back of a machine that was run with a special plate.

Compatibility and scope of supply

The plate belongs to the long Supercut/LN5L cutting machine (Iteco 7915.041L). For the short LN5 machine the plate 340.111 applies. Intermediate plates of up to 3 mm increase the cut length of the LN5L. Supplied as one plate. Made in Italy.