Preforming and cutting die assembly 90 degree lead bending for Supercut/RS4 - Iteco 161300

When an enclosure lid sits close above the board, a leaded component has to lie down rather than stand up. This Supercut/RS4 die bends the leads through 90 degrees and cuts them to length in the same stroke, so the part can be mounted parallel to the board.

Features

• The 90 degree bend lays the part parallel to the board and reduces build height to the body diameter
• Bending and trimming in the same foot operated stroke, no second operation
• Even bending radius protects the lead exit of the package
• Repeatable position of the body, therefore fewer height rejects before the lid is fitted
• Machine output 2000 pcs per hour with manual feed

Applications

Low profile assemblies in connector housings, power supplies and plug in units where upright capacitors or resistors do not fit under the lid.

Compatibility and scope of delivery

The die assembly fits the Iteco Supercut/RS4 (machine number 7915.166). Delivery comprises one complete die assembly as a single piece. The machine itself ships without a die and has to be ordered separately. The same lead shape is available for the stronger Supercut/TS1 (7915.171) under number 181300.

Origin

Manufactured by Iteco Trading in Italy.