Stand-off preforming die assembly for Superform/AF, lead 1 to 1.3 mm - Iteco 430700

Axial components resting flat on the board are hard to clean underneath and give off heat less easily. This preforming die assembly for the Superform/AF forms a 4 mm offset into both leads, so the body sits at a defined distance above the board. The assembly is designed for heavy leads of 1 to 1.3 mm.

Benefits in operation

• Offset dimension a of 4 mm gives a repeatable gap between component body and board.
• Covers lead diameters of 1 to 1.3 mm, the heaviest range of the Superform/AF die programme.
• Pitch P adjustable from 13 to 61 mm, so short resistors and long chokes are both covered.
• Die change without rebuilding the machine, and the preforming step can be switched off entirely.
• Both leads are formed in the same cycle, which keeps the offset position identical across the batch.

Typical applications

Mounting power resistors and chokes with a gap to the board, assemblies that must be cleaned underneath the component, applications with high dissipation in the axial part.

Compatibility and scope of delivery

The die assembly belongs to the Superform/AF accessory range (Iteco 7915095, 7915096, 7915097) and is exchanged against another assembly in the machine. The machine itself is supplied without a die. For thinner leads the catalogue lists the assemblies Iteco 420800 and 420750, and for the same lead range with reduced pitch the assembly Iteco 430900. Dimensions are taken from the die table of the Iteco catalogue 2026. Made in Italy.